Honda DC5 HID install

 

 

               Disclaimer: The following is provided as a GUIDE ONLY, and I do not take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!

 

AIM: Install HID's in a DC5 Integra

Tools: 10mm 3/8 socket; 3/8 extension bar; 3/8 ratchet; Phillips head screw driver; insulation tape

Steps:

Step 1

remove the front bumper bar, the yellow arrows point to screws that need to be removed, the blue arrows point to clips that need to be removed. to remove these clips lift the center part then pop out the clip.
















STEP 2

remove head lamp assembly, remove 4 nuts, see yellow arrows below, disconnect the lamps, see red arrows


















STEP 3

mount the HID transformer, undo the bolt from the guard, mount the transformer.








Also run the wires for the HID globe up to the engine bay through the cut out.

STEP 5
Install the HID globe




STEP 6

plug
in the transformer power feed from the head light low beam connector, make sure you wrap up the connector with insulation tape, also ensure correct polarity.





Final result





do the same for the other side and install your heal lamps and bumper in the reveres order you removed them.






Disclaimer: The following is provided as a GUIDE ONLY; I do Not take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!

 

 

                                                

 

 

 

                   

 

 

 

 

 


View My Stats